Removal of cylinder head:
- Remove the hydraulic jacks, spacer rings and nuts.
- Release the pressure.
- Connect the hydraulic hoses to the jacks and raise the pressure as stated in the manual(1000 bar). Loosen the nuts with a tommy bar
- Pull down the hydraulic jacks of the tightening tool and screw the jacks on to the stud.
- Position the cylinder cover tightening tool over the cylinder cover.
- Place the spacer rings over the cylinder head nut.
- Hook the engine room crane on to the lifting attachment on the top of exhaust valve.
- Lift away the cylinder cover completely and land it, on a couple of wooden planks.
- Remove and discard the sealing ring between cylinder cover and liner
Dear Sir,
pleasure to learn and have applied in my MEO CL 2 answer paper , and gained my achievement. Awaiting for your further this types of simple form of guidance regarding my / our further questions.
thanks with best regards ,