What are types of anchor used on ships ?

  1. High holding power (HHP) anchors
  • A “high holding power” anchor is to be suitable for ship’s use and is not to require prior adjustment or special placement on the sea bottom.
  • When special type of anchors designated “high holding power anchor” of proven superior holding ability are used as bower anchors, the mass of each anchor may be 75% of the mass required for ordinary stockless bower anchors in the Table 1.
  • For approval and/or acceptance as a HHP anchor satisfactory tests are to be made on various types of bottom, and the anchor is to have a holding power at least twice than of an ordinary stockless anchor of the same weight. Full scale tests are to be carried out at sea on various types of bottom and to be applied to anchors the weights of which are, as far as possible, representative of the full range of sizes proposed; for a definite group of the range the two anchors selected for testing (ordinary stockless anchors and HHP anchors) should be of approximately the same weight, and should be tested in association with the size of chain cable appropriate to this weight.

The length of cable with each anchor should be such that the pull on the shank remains practically horizontal, for this purpose a scope of 10 is considered normal but a scope of not less than 6 may be accepted. Scope is defined as the ratio of length of cable to depth of water.

Three tests shall be taken for each anchor and nature of bed. The pull shall be measured by dynamometer. The stability of the anchor and ease of breaking out should be noted where possible. Tests are normally to be carried out from a tug but alternatively shore based tests may be accepted.

Measurements of pull based on RPM/bollard pull curve of tug may be accepted instead of dynamometer readings. Tests in comparison with a previously approved HHP anchor may be accepted as a basis for approval. For approval and/or acceptance of high holding power anchors of the whole range of weight, tests should be carried out on at least two – sizes of anchors and the weight of the maximum size to be approved could be accepted up to 10 times the weight of large size tested.

About the author

Vikrant_sharma

Leave a Comment